Linley-15B1 7.5D 10.0H 1.5W Iron Corbel
$70.00
Linley 15B1
The Linley family of corbels are made from a simple scroll pattern that is laser cut from steel. The Linley family of corbels provides a scroll pattern that is classic. If you're looking for scrollwork, but aren't looking for a lot of it, this design is perfect for you. This bracket can be used for countertop support, shelf support and anywhere else that a decorative support bracket is needed.
Facts about this product
- There’s one 3/8” cut out to create the single width scroll from the front.
- Back-plate is 1-1/2" wide x 1/4" thick
- There are no castings on this bracket, it's all laser cut from steel and tig welded for a clean look.
- The 3 holes are 1/4" wide and are countersunk so that the screw will sit flush.
- Top plate holes are available upon request for a fee.
- Back-plate top holes are an 1/8" in from the side and 1" down from the top-plate
- Back-plate holes are 1" on center apart from each other
- The bottom hole is 3/8" up from the bottom of the back-plate
- Can support up to 150lbs if installed correctly.
Linley 15B1
The Linley family of corbels are made from a simple scroll pattern that is laser cut from steel. The Linley family of corbels provides a scroll pattern that is classic. If you’re looking for scrollwork, but aren’t looking for a lot of it, this design is perfect for you. This bracket can be used for countertop support, shelf support and anywhere else that a decorative support bracket is needed.
Facts about this product
- There’s one 3/8” cut out to create the single width scroll from the front.
- Back-plate is 1-1/2″ wide x 1/4″ thick
- There are no castings on this bracket, it’s all laser cut from steel and tig welded for a clean look.
- The 3 holes are 1/4″ wide and are countersunk so that the screw will sit flush.
- Top plate holes are available upon request for a fee.
- Back-plate top holes are an 1/8″ in from the side and 1″ down from the top-plate
- Back-plate holes are 1″ on center apart from each other
- The bottom hole is 3/8″ up from the bottom of the back-plate
- Can support up to 150lbs if installed correctly.
